Thermo Scientific Lindberg/Blue M 3-Zone (Center) Controller 1200C Furnace - Programmable + OTC

Click for Compatible Furnaces

Features of the CC58434PBC Furnace Controller

Control console is fully wired and includes a solid-state power module, ON/OFF circuit breaker and thermocouple input jack

Center Zone: One microprocessor-based PID control (proportional, integral, derivative)

End Zone: Two microprocessor-based PID control (proportional, integral, derivative) mimic the programmed profile of the center zone controller, but allow an offset up to 100°C (+/- 50°C). Offset is digitally displayed.

Programmable with one (1) stored program of sixteen (16) segments. Each segment includes one ramp and one dwell, so you can program 16 ramp/dwell cycles.

The ramp is used to vary the heat-up rate to your specified setpoint. The furnace will then hold the temperature at a set level.

Thermocouple input jacks for each zone.

An LED display simultaneously shows both setpoint and actual furnace temperatures in either °C or °F.

The controller can be positioned adjacent to or remote from the furnace, permitting applications in fume hoods or containment areas.

NOTE: Controller must be hard wired

Over-temperature Control

Adjustable digital overtemperature control

Protects furnace and load in the event of primary control circuit failure

Overrides main controller and shuts off power to furnace if high limit is reached

Manual reset required for safety

Operates via magnetic contacts through signal from independent thermocouple

Optional Accessories