Thermo Scientific Lindberg/Blue M Controller for 1200C Furnace 240V - Programmable + OTC

NOTE: Controller must be hard wired by qualified technician

Programmable with one (1) stored program of sixteen (16) segments. Each segment includes one ramp and one dwell, so you can program 16 ramp/dwell cycles.

The ramp is used to vary the heat-up rate to your specified setpoint. The furnace will then hold the temperature at a set level.

Control console is fully wired and includes a solid-state power module, ON/OFF circuit breaker and thermocouple input jack

Selectable self-tuning microprocessor-based PID control (proportional, integral, derivative) provides optimum thermal process and prevents overshoot

An LED display simultaneously shows both setpoint and actual furnace temperatures in either °C or °F

The controller can be positioned adjacent to or remote from the furnace, permitting applications in fume hoods or containment areas

Includes Adjustable Digital Over-temperature Control (OTC)

OTC protects furnace and load in the event of primary control circuit failure

OTC overrides main controller and shuts off power to furnace if high limit is reached

Manual reset of OTC required for safety

OTC operates via magnetic contacts through signal from independent thermocouple