Thermo Scientific Water Jacketed CO2 Incubator - IR Sensor
Part Number: 3020
Precision 3020 CO2 Laboratory Incubator
Thermo Scientific Water Jacketed CO2 incubators protect your cultures by surrounding them with an insulated triple-wall cabinet construction and a jacket of temperature conditioned water. This provides unsurpassed protection against unwanted heat loss, even in the event of a power outage.
These incubators are the ideal choice for laboratories concerned with exposing their cultures to potential disruption of power or significant ambient temperature fluctuations.
Unique triple-wall construction protects against ambient temperature fluctuations
Patented, heated dual-pane, inner-glass door minimizes condensation with improved responsiveness and faster temperature recovery
Exterior is 18 gauge, cold rolled steel with a high impact painted finish
Stainless steel chamber is seamless, non-corrosive, type 304, mirror finish...and exceptionally easy to clean
Removable water reservoir: generates relative humidity values up to 95% with rapid recovery rates that promote optimal cell growth.
High and Low alarms can be set to make certain correct temperatures are maintained
Provided with four stainless steel, perforated shelves which are easily installed and removed without tools
Remote alarm contacts are included for connection to an in-house alarm system
Stacking kit is included for dual stack configuration
Easy to Clean
Polished stainless steel interior with 100% coved corners is easy to clean, saves time, and reduces contamination risk
Sturdy stainless steel shelves and supports can be readily removed without tools for easy cleaning, autoclaving, or adjustment
Patented inner-door gasket is removable, cleanable, and adjusts continually to ensure a tight seal
Optional in-chamber HEPA filter snap-fits, making it easy to remove without tools.
CO2 Capabilities and Features
Range of 0-20%
Control accuracy: Better than ± 0.1%
Readability and Setability: 0.10%
Inlet pressure required: 15 PSIG (1.0 bar)
Fill Port: 3/8" hose (barbed)
Drain Port: 1/4" hose (barbed)
Access Port: 1.3" (3.3 cm) with removable silicone plug with filter
CO2 Inlet: 1/4" hose (barbed)
Optional Class 100 HEPA Filtered Air Protection
Class 100 HEPA airflow is the preferred method of protection for water jacket incubators.
In-chamber HEPA air filtration system continuously filters the entire chamber volume every minute, creating cleanroom Class 100 conditions to preserve your aseptic culturing environment.
Add the optional in-chamber HEPA filter to effectively address airborne contaminants from routine door openings, that are the primary source of contamination in most cell culture settings.
Part Number: 1902000
The Class 100 HEPA filter airflow system is is the preferred method of protection for water jacket incubators. In-chamber HEPA air filtration system continuously filters the entire chamber volume every minute, creating cleanroom Class 100 conditions to preserve your aseptic culturing environment. Add the optional in-chamber HEPA filter to effectively address airborne contaminants from routine door openings, that are the primary source of contamination in most cell culture settings. Factory installed.
Part Number: 190884
The stainless steel shelf kit includes shelf channels and the shelf. The incubator can hold a maximum of 17 shelves and comes with 4 already installed.
Part Number: 190647
Your incubator becomes mobile with this roller base. Easily move the incubator around the lab.
Part Number: 237016
The humidity pan is made of stainless steel and is easily removable. The incubator comes with a pan and this is a replacement.
Part Number: 1900067
Replacement HEPA and inline filter kit.
Part Number: 965010
A two stage CO2 regulator for the incubator.
Part Number: 3050
External gas guard for the Thermo Scientific Water Jacket CO2 incubators.