Thermo Scientific Thermolyne Atmosphere Controlled Ashing Furnace - D1, 14L

Click for Accessories

The Thermo Scientific Thermolyne Atmosphere Controlled Ashing Furnaces are ideal for coal and coke ashing procedures.

Features of the F6030CM-33-60 Furnace

Includes the D1 Digital Controller (see below for alternate controllers). Programmable with four (4) stored program of sixteen (16) segments. Each segment includes one ramp and one dwell, so you can create four programs with 16 ramp/dwell cycles. The ramp is used to vary the heat-up rate to your specified setpoint. The furnace will then dwell (hold the temperature) at a set level for a specified time. An LED display simultaneously shows both setpoint and actual furnace temperatures.

Reaches 975°C with the standard stainless-steel manifold and 1093°C with the optional inconel manifold

Adjustable gas flowmeter/valve (0-80L/min) on front for easy access when adjusting the airflow rate

Stainless-steel manifold at rear chamber prewarms incoming gases and provides a maximum temperature gradient of only ±3°C at 750°C

Chamber rear has a 0.95cm (0.38in.) diameter port for monitoring chamber temperatures with independent measuring devices

Includes 0.64cm (0.25in.) I.D. or 0.96cm (0.375in.) O.D. hose barb (in back of chamber) for inert gas line

Includes two dual-purpose stainless-steel trays and handle to accommodate 24 (30mL) porcelain crucibles or 38 (10mL) quartz crucibles

Meets ASTM® D3174 specifications: 3 to 4 air exchanges per min.

Can be programmed to norm: "Heating rate of 8°C/min. to 500°C, 6°C/min. from 500°C to 750°C, Hold at 750°C for two hours, then turn off automatically"

CSA Certified, CE Marked

(PDF Download) Thermolyne Atmosphere Controlled Ashing Furnaces

Alternate Controller Options

The F6030CM-33-60 furnace includes the D1 digital controller and is also available with alternate digital controllers allowing for various levels of control and programs.

B1 - Single setpoint with one ramp and one dwell. The ramp is used to vary the heat-up rate to your specified setpoint. The furnace will then dwell (hold the temperature) at a set level for a specified time. Single display shows actual temperature or setpoint.
View B1-Controlled Unit, F6020C-33-60

C1 - Programmable with one (1) stored program of eight (8) segments. Each segment includes one ramp and one dwell, so you can program 8 ramp/dwell cycles. The ramp is used to vary the heat-up rate to your specified setpoint. The furnace will then dwell (hold the temperature) at a set level for a specified time. An LED display simultaneously shows both setpoint and actual furnace temperatures.
View C1-Controlled Unit, F6020C-33-60-80

Optional Accessories