Thermo Scientific Thermolyne A1 Premium Muffle Furnace

Click for Accessories

Thermo Scientific Thermolyne Premium Large Muffle Furnace features a robust design and a choice of four temperature controller models, making it perfect for industrial applications. This furnace provides a spacious 14L (0.5 cu ft) capacity and reaches a maximum of 1200°C, making it ideal for ashing organic and inorganic samples and conducting gravimetric analysis.

Features of the F6010 Furnace

Includes the A1 Digital Controller (see below for alternate controllers). Single setpoint to hold a specified temperature. Single display shows the actual temperature or setpoint.

Four heating elements are located on the chamber top, bottom and sides for enhanced temperature uniformity

Built-in vent port removes undesirable contaminants and moisture to extend the life of the element and unit

Rear of chamber incorporates a 0.38-inch diameter port for monitoring chamber temperatures with independent measuring devices

Optional stainless-steel shelf doubles load capacity (maximum temperature of 900°C)

Door safety switch stops power to heating elements when door opens

Thermocouple break protection cuts power to the heating elements, preventing a thermocouple failure runaway condition

CSA approved

(PDF Download) Thermolyne Benchtop Muffle Furnace

Alternate Controller Options

The F6010 furnace includes the A1 digital controller and is also available with alternate digital controllers allowing for various levels of control and programs.

B1 - Single setpoint with one ramp and one dwell. The ramp is used to vary the heat-up rate to your specified setpoint. The furnace will then dwell (hold the temperature) at a set level for a specified time. Single display shows actual temperature or setpoint. A mechanical overtemperature protection relay is also included.
View B1-Controlled Unit, F6020C

C1 - Programmable with one (1) stored program of eight (8) segments. Each segment includes one ramp and one dwell, so you can program 8 ramp/dwell cycles. The ramp is used to vary the heat-up rate to your specified setpoint. The furnace will then dwell (hold the temperature) at a set level for a specified time. An LED display simultaneously shows both setpoint and actual furnace temperatures. A mechanical overtemperature protection relay is also included.
View C1-Controlled Unit, F6020C-80

D1 - Programmable with four (4) stored program of sixteen (16) segments. Each segment includes one ramp and one dwell, so you can create four programs with 16 ramp/dwell cycles. The ramp is used to vary the heat-up rate to your specified setpoint. The furnace will then dwell (hold the temperature) at a set level for a specified time. An LED display simultaneously shows both setpoint and actual furnace temperatures. A mechanical overtemperature protection relay and RS-232 communications interface are also included.
View D1-Controlled Unit, F6030CM

Optional Accessories