Thermo Scientific Lindberg/Blue M 3-Zone (Center) Controller 1200C Furnace - Programmable

Click for Compatible Furnaces

Features of the CC58434PC-1 Furnace Controller

Control console is fully wired and includes a solid-state power module, ON/OFF circuit breaker and thermocouple input jack

Center Zone: One microprocessor-based PID control (proportional, integral, derivative)

End Zone: Two microprocessor-based PID control (proportional, integral, derivative) mimic the programmed profile of the center zone controller, but allow an offset up to 100°C (+/- 50°C). Offset is digitally displayed.

Programmable with one (1) stored program of sixteen (16) segments. Each segment includes one ramp and one dwell, so you can program 16 ramp/dwell cycles.

The ramp is used to vary the heat-up rate to your specified setpoint. The furnace will then hold the temperature at a set level.

Thermocouple input jacks for each zone.

An LED display simultaneously shows both setpoint and actual furnace temperatures in either °C or °F.

The controller can be positioned adjacent to or remote from the furnace, permitting applications in fume hoods or containment areas.

NOTE: Controller must be hard wired

Optional Accessories